10GBASE-ZR SFP+ Optics Module, up to 80km over duplex SMF Juniper Compatible
Product description
The SFP-1080-ZR is a long haul single-mode 10G SFP+ optical module compatible with the 10GBase-ZR specifications.
It uses a cooled EML laser transmitter at 1550nm and an APD photodiode. Line rate of transceiver is 10.3125Gbps.
Tested and found compatible on various 10G Ethernet switches to make sure the performance.
Features
1. Compliant with SFF-8431 and IEE802.3ae
2. Data rate selectable ≤4.25Gbps or 9.95Gbps to 11.3Gbps bit rates
3. Cooled EML transmitter and APD receiver
4. Link length up to 80km
5. Low Power Dissipation
Electrical Characteristics (TOP(C) = 0 to 70 ℃, TOP(I) =--40 to 85 ℃,VCC = 3.13 to 3.47 V)
| Parameter | Symbol | Min. | Typ | Max. | Unit | Note |
| Transmitter |
| Differential data input swing | VINPP | 150 | | 1200 | mVpp | 1 |
| Transmit Disable Voltage | VD | VCC-0.8 | | Vcc | V | |
| Transmit Enable Voltage | VEN | 0 | | 0.8 |
| Input differential impedance | Rin | | 100 | | Ω | |
| Receiver |
| Differential data output swing | Vout,pp | 350 | | 700 | mVpp | 2 |
| Output rise time and fall time | Tr, Tf | 28 | | | Ps | 3 |
| LOS asserted | VLOS_F | VCC-0.8 | | Vcc | V | 4 |
| LOS de-asserted | VLOS_N | 0 | | 0.8 | V | 4 |
Note:
1. Connected directly to TX data input pins. AC coupling from pins into laser driver IC.
2. Into 100Ω differential termination.
3. 20 – 80%. Measured with Module Compliance Test Board and OMA test pattern. Use of four 1’s and four 0’s sequence in the PRBS 9 is an acceptable alternative.
4. LOS is an open collector output. Should be pulled up with 4.7kΩ – 10kΩ on the host board. Normal operation is logic 0; loss of signal is logic 1.
Optical Characteristics (TOP(C) = 0 to 70 ℃, TOP(I) =-40 to 85 ℃,VCC = 3.13 to 3.47 V)
| Parameter | Symbol | Min. | Typ | Max. | Unit | Note |
| Transmitter |
| Operating Wavelength | λ | 1530 | | 1565 | nm | |
| Ave. output power (Enabled) | PAVE | 0 | | 5 | dBm | 1 |
| Side-Mode Suppression Ratio | SMSR | 30 | | | dB | |
| Extinction Ratio | ER | 8.2 | | | dB | |
| RMS spectral width | Δλ | | | 1 | nm | |
| Relative Intensity Noise | RIN | | | -128 | dB/Hz | |
| Output Optical Eye | Compliant with IEEE 0802.3ae |
| Receiver |
| Operating Wavelength | λ | 1260 | | 1610 | nm | |
| Receiver Sensitivity | PSEN1 | | | -23 | dBm | 2 |
| Recevier Reflectance | Rrx | | | -27 | dB | |
| Overload | PAVE | -7 | | | dBm | |
| LOS Assert | Pa | -37 | | | dBm | |
| LOS De-assert | Pd | | | -28 | dBm | |
| LOS Hysteresis | Pd-Pa | 0.5 | | | dB | |
Notes:
1. Measured with worst ER=9dB
2. PRBS 231 – 1 and BER<10-12@10.3125G
Applications
● 10G Base-ZR
● 10G Fiber Channel
● SONET, SDH networks
● 10G Ethernet
Compatibility
Olinkcom's Juniper Compatible 10GBASE-ZR SFP+ transceiver can be worked with the below Juniper networks equipment.
• EX2300-24T
• EX2300-24P
• EX3300 Ethernet Switch-EX3300-24T
• EX3300 Ethernet Switch-EX3300-48T
• EX3300 Ethernet Switch-EX3300-48T-BF
• EX3300 Ethernet Switch-EX3300-24P
• EX3300 Ethernet Switch-EX3300-48P
• EX3300 Ethernet Switch-EX3300-24T-DC
